Vickers Vernon Part 4 - "If it's not right, it's wrong!"

This latest post will sadly show less progress with the Vernon, than I would have liked.  Not that I've been idle you understand, in fact I've been very busy.  However, on more than one occasion over the past few days I've discovered little annoyances with various projects which have left me to conclude; "If it's not right, it's wrong!".  And upon discovering something which isn't as good as I can make it be, then I just have to begin again.  All to often, the inner perfectionist in me has abandoned a project for the sake of a detail which once seen, I cannot un-see.

Therefore, whilst the progress on the model may be slight, the learning curve has been projecting upwards, and the light at the end of the tunnel is becoming ever more welcoming!  And, rather than give-up, I've faced my demons and pushed through which feels good.  This photograph shows some of the failures, I think there may be two or three more which flew into the bin!!

My first challenge, was with the material I was using.  A new supplier had dispatched stock just over the quoted thickness, by .12mm.  That's point-one-two mm, not 12mm!  Now, this might not seem like much.  However, I like to design parts like these which fit together with a satisfying snap and will hold in position without glue.  I can then apply thin CA glue to the joints once I know everything is just-so.  I even consider the width of the laser cut (.17mm), and figure this into the part design to make sure all is good.

Unfortunately, the thicker material just didn't fit the tight tolerances I had designed to, which caused all sorts of problems, the most obvious of which is shown below.

In this case, the increased thickness of the wing ribs, when forced into corresponding notches in the spars, caused the spars to deform.  
This is why the wings on prototype 5 below are drooping.  :(

Having determined that particular problem, I had to modify each notch on my plan to correct the fuselage framework. Here is the kit of parts.

Rather than give a blow by blow account of all the failures, I'd like to focus upon some design criteria which I felt were important to the build.  
But first a shot of my progress thus far.  Here I've used an Ash veneer to clad the fuselage framework, and balsa blocks for the nose shape.  In these pictures I'm yet to finesse the final shape, but hopefully you get the idea.

I was keen for the interior to closely match the original design, and I'm quite pleased with the outcome. I chose not to paint the sides, to enhance the contrast of the frames when viewed through the little windows.

Another detail which was important to me, was the wing roots.  On the prototype they stop short of the fuselage, their only connection being the wing spars.

 

Being aware that this little plane might be somewhat fragile, and that I was likely to destroy most of it in the construction process, I have made the upper wing removable.  To achieve this the vertical structural pieces between the wings were made to fit into pockets between two wing ribs.  Upon completion of the wing covering, the hole is cut from the tissue covering material, and these pieces simply slip in, their profile neatly finishing the hole flush with the upper surface of the wing.  

  

The result of these improvement are, I think quite realistic especially so when one remembers the scale of 1:56.  

For these photos I was keen to add some colour and so have blown a quick coat over the upper wing and rear fuselage section.  I'm still to determine the correct colour of the prototype, so for now green it is.

I am really happy with the contrast between the front and rear sections, their construction methods closely reflecting the prototype. 

And finally, rather precariously perched upon its embronic landing gear the aeroplane is being guarded from the marauding children at school by some Empress miniatures, who may or may not get a coat of paint themselves at some point in time.

And so, that is the progress so far.  Sadly not the progress I'd hoped for, however, the rest should be fairly straight forward from here on.

Thank you for visiting the blog.